a problem

I will take it out as soon as i am back in the office



thanks


another question

sometimes after i boot from power off to power on i can not see my tape
drive in server but usually a warm boot will fix it.

i enclose my startup file with my autoexec

i use tapeware from yosmite

do have any advice
steve
"Niclas Ekstedt" <niclas.ekstedt@nospam.infrasystems.se> wrote in message
news:pan.2005.06.04.09.05.40.417006@nospam.infrasy stems.se...
> On Sat, 04 Jun 2005 07:00:58 +0000, steve hall wrote:
>
> They both look good. I just remembered that legacy auditing
> didn't have any separate modules that were loaded on the server
> as the later auditing products does.
>
> I see that you in the autoexec.ncf load WTM.nlm, this is WAN
> Traffic Manager, do you actually use this? If not try to remove
> it from autoexec.ncf and restart the server. When the server is
> back up, try to use auditing again.
>
> --
> //Niclas Ekstedt
> ____________________________________________
> Niclas Ekstedt, CNA/CNE/CNS/CLS
> Network Consultant/NSC Sysop
> InfraSystems Solutions
> ____________________________________________
> (Sorry, support is not provided via email)
>