How Do You Image SLES 10 SP1 and Boot it?

Ok I was sent over to this forum from the SLES 10 forum.

How do I image SLES 10 SP1? I have a SLES 10 SP1 server set up and I want
to image it to 15 other workstations and send them out. It has a bunch of
additional stuff on it so I don't want to AutoYAST it. I simply want to
image it and then change the host name on it. I didn't install a CA on it.

I am using ZenWorks 7 SP1 HP5 Imaging and I can image the machine fine,
but once I restore it on a different machine it won't boot. The one
machine I tried it would hang on GRUB_.... the other machine I tried it
would hang on boot not finding the hard drive it was looking for.

I am using the IDENTICAL hardware. Basically all Lenovos M55 with the
exact same Seagate 500GB hard drive brand. I am using EXT3 with ZenWorks
Imaging. It hangs looking for a hard drive number like the following:

Loading ext3
Waiting for device /dev/disk/by-id/scsi-SATA_ST3500630AS_5QG1H556-part2 to
appear...............
not found--exiting to /bin/sh
$

Can't do anything after that.