HI All,

When i run the initial install, the gilr appliance wont pickup the raw lun (esxi.5.5) to cinfigure for data storage, but when i finish the install and go to yast, i can in partitiona manager create the partition, how can i trigger the initial install again .. i have tried the "NovellVainit" under yast , but that does not again adress the storage/partions, just passwords , dns etc etc ..

So guess i am looking for somtething or how to clear th efilr config so that when i startup, it takes me to the initial configuration steps, so i can then point to my storage i created in yast before... those this make any sense ...

Kind Regards,