Hi,

two node cluster 6.5 and SP4 just installed.

After SP4 installation node 2 boots right but node 1 stops at Stage 1.
Cluster is connected to a CX500 SAN System and servers are using QL 2340.

Powpath 3.0.4
QL2300.HAM 6.80.07
QLOGIC Firmware 1.42

I have noticed that server hangs when is processing Stage 1 NLM's. Then
I modified Starup.ncf and Powpath and HBA are loaded when server is
completely booted. Then I make and LDNCS and all Cluster works fine.

Startup.ncf#LOAD POWPATH.CDM

LOAD ACPIDRV.PSM
######## End PSM Drivers ########
LOAD SCSIHD.CDM
;(commented out by Array Manager install...)LOAD QLCSFTE.CDM
#LOAD NWTAPE.CDM
LOAD IDECD.CDM
LOAD NWASPI.CDM
LOAD NWTAPE.CDM
######## End CDM Drivers ########
LOAD AIC78U2.HAM SLOT=10006
LOAD IDEATA.HAM SLOT=10009
LOAD PERC2.HAM SLOT=10017
#LOAD ADPT160M.HAM SLOT=10019

#LOAD QL2300.HAM SLOT=4 /LUNS /ALLPATHS /PORTNAMES /QUALIFIED /LUNZERO
#LOAD QL2300.HAM SLOT=5 /LUNS /ALLPATHS /PORTNAMES /QUALIFIED /LUNZERO

######## End HAM Drivers ########
Load Keyb Spain
Load Charset CP850

Thanks in advance.

Regards.