Nwagent.nlm hung the server over night during the backup. There was an
error message but the attending systems admin rebooted the server
before reading the error. Server has been working fine in terms of no
failed backups or previous hangs when nwagent.nlm is loaded. I have
nothing in the abend log or in the
"Sys error log" And only the errors below from the logger screen I
haven't reloaded the nwagent.nlm for fear it may hang the server again.

Should I be concerned about any of the messages below and two any one
have a problem with nwagent.nlm hanging the server I have the latest
and greatest service packs as well on my Novell 6.5 server. Thank you
for any help

NWMKDE-29: MicroKernel Database Engine (c) Copyright Pervasive Software
Inc. 1989-2001 All Rights Reserved U C M G R - 3 1 6 : S e r i a l
n u m b e r s y n c h r o n i z a t i o n e r r o r .
F i l e s h a v e b e e n s t a m p e d b u t t h e u s e r c o u n t k
e y f i l e d o e s n o t e x i s t . I f y o u h a v e m a d e a b a c
k u p
c o p y o f y o u r u s e r c o u n t k e y f i l e ( < p l a t > U C M
G R . S Y S ) , p l e a s e r e s t o r e i t t o t h e d a t a b a s e
e n g i n e
d i r e c t o r y . Module NWMKDE.NLM load status OK

Perl 5.8.4 - Command Line Interface Version 5.00.05 September 13, 2005
Copyright (C) 2000-01, 2004-05 Novell, Inc. All Rights Reserved. Can't
open perl script "SYS:/system/ipconf/nfau/nfauipmgmt_pull.pl": No such
fil e or directory

Module ISCSITAR.NLM load status OK iSCSI Target: !!!!!!!!! WARNING
!!!!!!!!! LDAP credentials have not been initialized on this server. If
target access control is required, then LDAP credentials must be
initialized first, and the target reloaded.
Btrieve SPX Communications Module Copyright (C) Pervasive
Software Inc. 2003 All Rights Reserved. BSPXCOM-20: An SpxOpenSocket()
error (150) has occurred. BSPXCOM-18: A thread initialization error has