Sorry in advance, if this is not the appropriate forum, but the other
forums related to the CIM interface were very developer specific.

1) It is my understanding that the OpenWBEM cimom.zip was packaged up, but
not installed by default, starting with Netware 6.5 sp3. Prior to that I
believe that it had to be downloaded directly from OpenWBEM, correct? Does
this mean that I must upgrade to 6.5sp3 in order to set up the CIM
interface, or is it supported on much older versions of Netware, such as
5.1 and 6.0, i.e. can I monitor those servers, as well?

2) If we wish to monitor multiple Netware boxes, do we need to have the
cimom installed on each of those boxes?

3) If we wish to monitor multiple Netware boxes, do we need to have
providers installed on each of those boxes?

4) Is there a central location on the Netware site, which provides greater
detail about the CIM interface from a customer install and setup
perspective(not developer)? Most of the links I found, make reference to
the interface only in relation to 6.5 sp3 and the OES version of Netware,
whereas we have several servers which are still running NW 5.1 and 6.0.

Any information you could provide would be very helpful.

Thanks,
NND