Hi all. I'm trying to use PING to reslove my two IP's on one NIC (double
etherenet card is what I call it). Anywho, I have the two IP's but on
TCPCON it only shows 3 routes. Here is the layout:

Destination next hop Type Cost interface remote 1 1 direct 1 2 direct 1 1

So, my flat network addresses are and I got
that. What happens is when I plug my laptop into the network
and try to ping my it responds. If however I plug my laptop
(I did change the IP scope from a 192.168.60.x to a 192.168.6.x) into my network and try to ping my it does not respond.
Any ideas would be great. Thanks! Oh, GW6.5 NW6SP5