Hi Folks,

I am moving from my current backup software to Arcserve 11.1 at each of my remote sites (stand-alone Netware servers with an internal tape drive).

The problem I have is that if I install Arcserve on the server, and then the manager on a workstation at the site, the workstation connects fine. When I attempt to connect to the server from my HQ location via the Arcserve manager on my desktop, it does not connect. I think this is a config issue on the workstation and maybe something in asconfig.ini, but it's been a while since I've use Arcserve.

Suggestions before I call CA tech support (ugh!)?