I have a Dell 2650 Server with two onboard Broadcom copper gig ethernet boards. I want to configure just one of them, in the NetWare OES NRM under PCI Devices how do I know what "hardware instance number" goes to what ethernet port on the back of the server? Is it always in order?

Right now the hardware instance number(s) are 10016 and 10017 would 10016 always go to eth 1 and 10017 always go to eth 2, in not is there a way to tell which goes to which?

I've never actually configured a board from scratch before so I'm a little fuzzy on the whole process. Thanks for any help.

David Mitchell