I've downloaded the eval software, and was intending to install it, and
then license it - we already have the license, but not the media. I tried
to install it on a brand new machine with the following config:

* HP Proliant ML350 G4
* Dual hot-swap PS
* 4x 36.4Gb UltraSCSI disks on a RAID controller (config'd as RAID-5)
* Xeon 3.0 GHz
* 2 Gb RAM

This system came with absolutely no OS pre-installed.

Once the process gets to INSTALL.BAT, the machine goes nuts. I can see the
word Debug, followed by a dump of something, flash on the screen, but then
the screen is blank. It beeps. That's it.

Any suggestions?