Upgrading from NW 5.1 to 6.5 with clean install on new server. After
installation of OES Netware 6.5 SP5, upon restart server called
debugger and hung with FATFS error (see info below). After much hair
pulling I discovered that while the dos 6.22 (500MB) partition was on
HD0, netware was installing on HD1. I removed the netware partition from
HD1, disconnected it, forcing NW6.5 to install on HD0, then rebooted and
it came up AOK. Reconnected HD1 and got the same hang with the identical
error message. This is SATA, but as near as I can tell is not a raid
board as it is ICH7, not R, and there are no raid settings in the bios.

Any thoughts greatly appreciated,
John

Error message:
Netware Debugger
Break at BECB4F7D because of debug procedure beging called
Current Focus Processor: 00
EAX=00000000 EBX=BECF7198 ECX=FE091F00 EDX=0000293D
ESI=000001C0 EDI=FFFEFFFE EBP=00000004 ESP=B882DF68
EIP=BECB4F2D FLAGS=00000002
BECB4F7D C3 RET
P00#

Upon entering ?, I get:
Address in FATFS.NLM at code start +000 8F7Dh
Previous: =00000033 BECB4F4A FATFS.NLM|GlogabBufferLock
Current: 00000000 BECB4F7D
Next: +00000001 BECB4F7E FATFS.NLM|GrobalBufferUnlock

Server Hardware is:
Intel P4D, 3GHz
Intel D945GTP M/B w/SATA Chipset ICH7
2GB DDR3200 RAM
2 - WD1500ADFD 150GB SATA H/D

Startup.ncf is:
ACPIDRV.PSM (10/03/05)
IDECD.CDM (01/30/06)
IDEHD.CDM (06/06/06)
IDEATA.HAM SLOT=1013 (06/06/06)
IDEATA.HAM SLOT=1014 (06/06/06)


____________________

John Harned
john@harneds.com
____________________