I just installed Small Business Suite v6.6 (nw 6.5) over nw 6.0sp4. This
was a fresh install on a single-server LAN, not an upgrade - very small
tree. The installation went great and the new SYS and the existing DOS
drive show up normally on HDETECT. However, I have several other IDE data
drives that show under DEVICES, but are reported without partitions and
therefore cannot be added to pools or volumes.

Nothing has been done to these drives, so I could reinstall 6.0 as a last
resort or recreate the partitions and restore from tape backups, but there
is a small amount of new post-backup data on the drives I would like to

So, how can I get nw 6.5 to see the 6.0 drive partitions?