Have a nw6sp4 server on an ibm x226 box w/ internal dds5 drive running
arcserve 9.01.

Got a good backup, now get a partial backup before it fails w/ an e1145
error (media error, sometimes says unit attention as well).

These are brand new tapes in a brand new tape drive, & the drive has
passed diags. I had forgotten to slow the transfer rate on the scsi
card (adaptec ultra 320), but did that & still no luck.

Once the backup fails, I need to power off/on the server to get the
tape to eject.

Any suggestions as to what can be done to get this working? I'm going
to try a different tape drive today, but then I'm out of ideas.