I am trying to set up Multipathing and this option is grayed out in
iManager and List Failover Devices produces nothing. Below is my setup -
wondering if anyone can point me in the right direction:

-2 DL380's running Netware 6.5 sp6
-set multi-path support = on in the startup.ncf
-both servers have 2 array controllers - an internal Smart Array 6i and an
add in Smart Array 642 in slot 1 - each attached to the HP MSA500 SCSI
-can see the disk device down both paths (both array controllers) from
both servers

Any ideas?