So then in a scenario where someone has a multiport jetdirect, and
wants to
maintain support for legacy queues used with DOS apps, that person
would be
out of luck, yes?

It doesn't appear that you can get the Novell PA to do both LPR and
legacy
at the same time. Even if you could, you can't specify a queue and
direct
that to port two or three anyway.

Any ideas?

I've played with DOSPrint as method of redirecting LPT ports directly
to
NDPS resources, but it only works with W2K. I still have 9x clients
out
there.

Thanks for any input.

Steve
"Craig Wilson" <craig_d_wilson@yahoo.com> wrote in message
news:3E327EAE.F633068B@yahoo.com...
> http://support.novell.com/cgi-bin/se...?/10066775.htm


>
> Step #5
>
> delaerj@baxter.com wrote:
>
> > Where and how do I set the LPR name?
> >
> > > define the LPR name as raw1,raw2, or raw3 depending on the port.


> > >
> > > delaerj@baxter.com wrote:
> > >
> > > > I am trying to setup a 3 port Jetdirect Card in IPrint and am

unable
to
> > > > specify which port I want to setup a specific printer on.

Does
anyone
> > > > know how to do this? Is it even possible, or do I need to

install
> > single
> > > > port Jetdirect cards? Thanks in advance for any advice.
> > >
> > > --
> > > Craig Wilson
> > > CNE3, 4, 5 - MCSE - CCNA
> > > NSC Sysop (http://support.novell.com/forums/)
> > >
> > > Tech Writer - http://www.ithowto.com
> > > (I Peter 4:10)
> > >
> > >

>
> --
> Craig Wilson
> CNE3, 4, 5 - MCSE - CCNA
> NSC Sysop (http://support.novell.com/forums/)
>
> Tech Writer - http://www.ithowto.com
> (I Peter 4:10)
>
>