Hi there!

(Spec info: Proliant ML350 G5, 2x scsi disks and 4xsata disks)
We've just installed Netware 6.5 through HP Smartstart, with a raid 1+0
setup on the two scsi discs, works properly. When we afterwards decided to
put in 4 sata disks, we used smartstart to configure a raid5 setup for
them, and they won't show anywhere in Netware. When we look at "Devices",
we can see one that's named "0x9" (Desc: HP Smart Array E200i Slot 0 LUN
0) which is the scsi 1+0 setup with the right size. And there is one
that's named "0xa" (Desc: HP Smart Array E200i Slot 0 LUN 1) which shows
0.00 bytes. In monitor, when i look under "storage devices", i can see the
"HP Smart Array E200i Slot 0 LUN 1", and beneath it it says "Unindentified
Media" Does anyone know what can cause the problem? Is there any
possibility that it hasn't installed the sata drivers along with the
installation when we didn't have any sata disks in?

Thanks!
Anders