I just changed form Zen7 Sp1 to Zen7 Sp1 HP2

I got plenty of Compaq D510 with ide drive.
With the sp1 only there were ok, but had problem with the DC7700.
Now when I'm booting with the d510 I got an error from udev
Udev event 3222 Create_node: symlink(../../hda,/dev/disk/by-path)failed file
exist

then i manually start a script that remove all partition an create 3
partitions on the drive
img pd-all
img pc1 ntfs 5000
img pc2 ntfs 5000
img pc3 ntfs
img pa1
when executing this script got many error in dmesg or f4 console

hda: task_in_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_in_intr: error=0x10 { SectorIdNotFound }, LBAsect=88539143,
sector=1162280967
ide: failed opcode was: unknown
......
hda: task_in_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_in_intr: error=0x10 { SectorIdNotFound }, LBAsect=88539143,
sector=1162280967
ide: failed opcode was: unknown
hda: task_in_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_in_intr: error=0x10 { SectorIdNotFound }, LBAsect=88539143,
sector=1162280967
ide: failed opcode was: unknown
ide0: reset: success
hda: task_in_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_in_intr: error=0x10 { SectorIdNotFound }, LBAsect=88539143,
sector=1162280967
ide: failed opcode was: unknown
end_request: I/O error, dev hda, sector 1162280967
hda: hda1
hda: hda1 hda2
hda: hda1 hda2 hda3
hda: hda1 hda2 hda3

But on the console there is no error, but after 2-3 minutes the prompt is
back and I can image.
On the old kernel take about 5-20 seconds.

When Imaging it take about 5-10 time longer then before I changed the
kernel.
was 5-6 minutes now takes 25-45 minutes

img restorep $PROXYADDR //$PROXYADDR/image/partition_c.zmg a1:p1
img restorep $PROXYADDR //$PROXYADDR/image/partition_d.zmg a1:p2
img restorep $PROXYADDR //$PROXYADDR/image/partition_e.zmg a1:p3

On sata drives there is no problem.


Is someone having the same behavior?

thanks