Using the Zenworks 7 boot cd I'm doing the following:

Deleting existing partitions on the hard drive
img pd1
img pd2
fdisk to remove existing zenpart if needed

Installing 3GB Zen Partiton
install.s

Formating the drives ntfs
img pc1 ntfs 40%
img pc2 ntfs 50%

Loading image of c: drive to the 1st ntfs partiton
img rp $server //$server/vol1/images/winxpbase.zmg a1:p1

Loading image of c: drive to the 1st ntfs partiton
img rp $server //$server/vol1/images/winxpddrive.zmg a2:p2

make 1st partition active
img pa1

The images come down, I run lilo.s, and reboot.

The initial reboot results in the Suse startup screen (like booting to the cd). If I leave the option on automatic it will say ....re-installing the boot code, after that it will reboot and WinXP will load. Each time I reboot though it goes through this process again.

Any ideas what I'm doing wrong? I'm pretty sure it's something simple....however, my Linux skills are pretty much non-existent :)

Thanks!