Running ZfD on NetWare.

After upgrading to ZfD7 SP1, dinic.sys won't pickup harware information
anymore

It works on some machines, but most of the times the zenpxe.log is missing
out the harware info.

Dumping Workstation Information:
WorkstationInformation.signature ............ ZENWSINF
WorkstationInformation.version .............. 5
WorkstationInformation.length ............... 3640
WorkstationInformation.Chipset ..............
WorkstationInformation.Video ................
WorkstationInformation.Network ..............
WorkstationInformation.Soundcard ............
WorkstationInformation.Diskcontroller .......
WorkstationInformation.BiosAssetTag .........
WorkstationInformation.BiosSerialNumber .....
WorkstationInformation.HarddriveSizeMB ...... 0
WorkstationInformation.RAM .................. 0
WorkstationInformation.MACAddress............
0000:0000:0000:0000:0000:0000
WorkstationInformation.ipAddress ............ 0.0.0.0
WorkstationInformation.BootMedia ............ 0
WorkstationInformation.zenPartitionType...... 0x00


This means that imaging operations initiated from the workstation object
(Put an image on this workstation on next boot) fails, since the workstation
imaging policy don't get any hardware info to perform the image selection...

If holding down Ctrl-Alt during boot and select the first meny item (Start
zenworks imaging), the image operation starts as expected.

So the img utility do extract the hardware info correctly, but dinic.sys
don't...

dinic.sys is dated march 22 2006.