Aaron McLaughlin wrote:
> I am having an issue where if I go into ConsoleOne and set a workstation
> to image on the next reboot, when the workstation reboots it says there
> is no work to do and boots into Windows.
>
> What I have done so far is, I have installed the linux partition, then I
> install an image onto the workstation, after that I type lilo.s. The
> workstation gets imported and I can remote control the workstation
> through ConsoleOne. But I can't set them up to image on reboot. I have
> checked the workstation image object and all looks correct.
>
> Any suggestions would be appreciated.
>
>
> Thanks
>

Ok, I ran img i z and there is image safe data. I also ran imgserv
-debug and here is a part of the log:

Mon Oct 25 15:51:51 2004 -- [GWTD] 1067
Mon Oct 25 15:51:51 2004 -- [RAD] Error -603, "zenimgImagingService",
"ADMINSRV1.North_Newton"
Mon Oct 25 15:51:51 2004 -- [LAIS]: RAD error, -603
Mon Oct 25 15:51:51 2004 -- [GWTD] LAS failure, -603
Mon Oct 25 15:51:51 2004 -- [AO] "CN=NN1327W07
00:0A:5E:2F:A3:A0.OU=Workstations.O=North_Newton"
Mon Oct 25 15:51:51 2004 -- [GEMI] -603
Mon Oct 25 15:51:51 2004 -- [GWTD] done, -603
Mon Oct 25 15:51:51 2004 -- [HC] done, PROXY_CMD_CHECK_WS
Mon Oct 25 15:51:51 2004 -- [HC] received PROXY_CMD_CLOSE