Hi All,

Were experiencing problems with our Zfd65 running on our NW65 Cluster.

Were running 2 NW65(sp4a) nodes in our Cluster(NCS 1.8.0) with ZFD65sp2.
We have DHCP and PDHCP running on the same Resource with TAG60 set. We did
start out with DHCP and PDHCP on different resources but later changed
them to the same resource after a couple of TID's suggested they run from
the same resource IP.

The client PXE process boots and picks up the DHCP address etc and
downloads from the TFTP server but then says something like this;

################################################## ######

Auto-select:
ZENworks Boot

BOOT SERVER IP: 10.XXX.XXX.XXX
ZENworks Preboot Management Client V5.0 r2 (Build 105)
(c) Copyright 1999-2003 PreWorx (Pty) Ltd.
Local IP :10.XXX.XXX.XXX
Subnet Mask :10.XXX.XXX.XXX
Transaction Server IP :10.XXX.XXX.XXX
Gateway IP :10.XXX.XXX.XXX
ZenWorks Preboot Shutting Down...
Press any key to continue...

################################################## ######

This is as far as it gets, then reboots. I've tried every combination I
can think of in the PDHCP, DTS and TFTP.ini files with know luck.

I see a couple of others on here with similar issues. Does anyone have a
setup like this running imaging correctly...?


NW65sp4a or 5
NCS 1.8.0
ZFD65sp2

If your imaging ok with the obove, I and a couple of other would love to
hear how you did it!....