I have a Dell Latitude D520 loaded with the factory OS that includes two
partitions on the HD. I like to capture an image of the factory OS
installation before reimaging with our own image. This way if a problem
comes up I can use the factory image for troubleshooting.

Unfortunately The Zenworks Boot Cd Ver. does not seem to be picking
up all the partitions on the disk. When I do a manual make image and I
look under the section for "Include Partitions" it only shows one partition.

If I look at the partitions with FDisk it shows all the partitions just
fine. One is a Non Dos and the other is NTFS.

Also when dumping an image it is not overwriting the existing partitions.
How do I get it to lay down only the partitions that are in the image?