Prior to Arcserve 11.1.3 I've been backing up my Groupwise server using
the TSAFS agent, since it didn't support TSAGW anymore. I've restored my
PO a few times to recover mailboxes without a problem, so I have no
issue with the current setup. It works.

I've been running sp3 for Arcserve for 2 weeks now and it's working
happily. But unless I was dreaming, I'm sure I read somewhere sp3
supports TSAGW again (I've been trying to check the CA KB site but it's
timing out).

Is this the case? If so, has anyone tried it, and am I better off using it?