Just upgraded from as9.1 to 11.1 sp3, and I noticed that alot of the btrieve settings are different. From browsing through here, the only recommendations I saw were to change the "maxcache" to 10 from 60, and then a couple of additional lines in the asconfig.ini file under [netware backupandrestore]
UseMultipleReadThreads=FALSE
PerformanceNonNakoma=TRUE

So I did that...but I'm wondering about all the other common suggestions for performance and so forth that were added, often at the suggestion of CA, to these config files...

cachesize
maxfiles
maxcursors
maxclients
backgroundthreads

maxworkerthreads
maxrecsize
maxclients

These have all reverted back to much smaller numbers than where they were set for 9.1.
any recommendations for 11.1, or should I just leave 'em alone until/if there is a problem?
(I did do the upgrade to btrieve8.5)

thanks...

-chuck