I've just done a new install of OES2 on a Compaq DL380. I can't get xWindows
or any other type of GUI to show up. When I run YAST (in text mode of
course) and look at the hardware I can see that right monitor and graphics
are being detected. I am using a KVM switch if that makes a difference. This
is the error message that I get in the /var/log/Xorg.0.log file...

X Window System Version 6.9.0
Release Date: 21 December 2005
X Protocol Version 11, Revision 0, Release 6.9
Build Operating System: SuSE Linux [ELF] SuSE
Current Operating System: Linux ecftp #1 SMP Thu May 17
14:00:09 UTC 2007 i686
Build Date: 18 May 2007
Before reporting problems, check http://wiki.X.Org
to make sure that you have the latest version.
Module Loader present
Markers: (--) probed, (**) from config file, (==) default setting,
(++) from command line, (!!) notice, (II) informational,
(WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/var/log/Xorg.0.log", Time: Wed Feb 27 19:14:08 2008
(==) Using config file: "/etc/X11/xorg.conf"
Data incomplete in file /etc/X11/xorg.conf
At least one Device section is required.
(EE) Problem parsing the config file
(EE) Error parsing the config file

Fatal server error:
no screens found

Please consult the The X.Org Foundation support
at http://wiki.X.Org
for help.
Please also check the log file at "/var/log/Xorg.0.log" for additional

(WW) xf86CloseConsole: VT_GETSTATE failed: Bad file descriptor
(WW) xf86CloseConsole: KDSETMODE failed: Bad file descriptor
(WW) xf86CloseConsole: VT_GETMODE failed: Bad file descriptor