It seems that if I have two qlogic cards in the blade and I'm booting
from the SAN, that SLES shows two disks (sda and sdb).

Only one of them is "bootable"

Is this normal and if so, it seems that it sees \sdb as the bootable one
(it's the only one listed with a SCSI device ID).

I know with NetWare there issues if you let the OS see both paths (you'd
end up with some serious SYS volume renaming going on).

Do I need to just progress with the install and then afterwards install
the Qlogic stuff from HP or let SLES use it's native drivers?