I am using the most recent zcm 10.03

However, while creating an image of Dell Vostro 200 and 400 tower using PXE option, I am getting the following error:

"Could not find the Zenworks Installation Source .... Activating Manual Setup Program' with the OK prompt.

I also used the Boot CD. The program seems to run fine. However, after I enter all details (Image name), I get an error message "Cannot connect to the IP Address"

We have been using imaging fine so far without any problems. (Both PXE and boot disk options work fine)

Does anyboby have a solution? The problem is I think (like the problem was with the e1000 driver for Optiplex 755(before 10.03) ) the way zcm handles the e100 driver.