I'm new to the zen imaging, been using ghost for years, also new to the more advanced switch setup here. I have a cisco 2950 switch setup, windows gets dhcp address' no problem. When using a zen imaging cd , it will not get a dhcp address. When you bypass the switch and go direct to the 6509 it gets a address fine.

If you move the device being imaged back to the 2950 after it obtains a address it will image just fine. I know its a lot more involved than I can get in a email but anyone have any suggestions on what I may have missed on the 2950?

Just odd, windows will get a dhcp address but the zen imaging will not, even on the same laptops.