I got physical servers with 2 GB NICs, these NICs are connected to diffrent
GB switches.
I want eth0 to always be the priority one.

When eth0 fails (cable out, switch down etc.) it fails over to eth1, so good
so far....
When eth0 is back in buisness I want it to switch back to eth0. This does
not work as

I use mode=1 (hot standby) miimon=100 and use_carrier=1 as bonding options
for my
two nics.

Can someone tell me how to get that eth0 to fail back. I dont think it's
possible in SLES10
without manual operation.


Anders Bengtsson