Hi All,

Not sure exactly what is causing the problem, but if you turn off your firewall on the workstation, user policies will successfully deploy from ZCM 10.1

This was tested on Vista Enterprise x64 SP1. I haven't wiresharked it yet, but I'm guessing some key Agent ports are not opened up during the install of the ZCM agent.

I'm going to try and check this with Wireshark.

I actually stumbled across this because I noticed that the Zenworks Agent was unable to obtain a status from my Vista machine, yet I could do policy refreshes, but not device refreshes. SOOO, disabled the firewall and BAM! my user policy that hadn't shown up suddenly installed and did what it is supposed to.