I have installed the Groupwise Messenger Server on my Netware 6.5 server and that went ok. I pretty much used the default settings. When I load the nmstart.ncf manually after the install, it looks like it loads fine on the server. However, when I installed my client, I get the following message: "The client is unable to connect to the server. Verify that the remote address and port are defined correctly." Now, I can ping my netware server just fine from my workstations so I don't have any clue where to start troubleshooting. Any help will be much appreciated....Note: I have not tried restarting my netware server yet.