Hi all,

I'm currently installing two OES2SP1 servers, both attached to two iSCSI targets (plain servers with Openfiler installed). The targets should act redundantly for eachother.
I was thinking of doing the following:
1. creating a SBD partition on one target and mirrorring it to the other.
2. creating a NSS volume on one target and creating a software RAID 1 with the other iSCSI target.

Would this be a good plan?
An alternative might be to install iSCSI on the two targets and have it failover with DRBD and heartbeat, but that's a lot more complicated.