Starting on a new system I
Installed NW6SP3
Had a problem with the 39160 drivers for the tape drive.
Had to replace some *.ham files on C:
CDROM.NLM was not on the system after install???
Install Backup Exec 9.0
Rebooted, Tested, everything looking good
Install BM3.7
Reboot
Install BM3.7SP2
Reboot - So far good

Run through
UNLOAD IPFLT
UNLOAD FILTSRV
LOAD FILTSRV MIGRATE
UNLOAD FILTSRV
LOAD FILTSRV
REINITIALIZE SYSTEM
Reboot

System comes up and almost locks.
Bordermanager is stopped while Reading NDS Config. Info.
If I try and run anything (Edit,Ping) it locks there.
I can still change from screen to screen.
Once it does that I have no choice but to shut off the power.
Is there no way start a new prompt and kill a processes in NW?
I wish NW7 with Linux was here.

I have rebuilt this system twice with the same results.
I must be missing some unlisted step listed on some forum somewhere.

Thanks,
Unhappy James...