We are running BM 3.7 sp2. Had some trouble this weekend where no one

could get out or in, and it turned out to be a switch that sat between

our router and our BM server. However, in trying to figure it out
(since that switch was put in without consulting any of us NW techs),
I
thought it might be a NIC going bad on the server. I added a network

card to replace the on-board NIC, and then we found the problem, so I

switched back to the on-board NIC. I made sure all the filters and
filter exceptions were set back properly, and most internet traffic
works. However, the web authentication page does not work. I just
get
"page cannot be displayed" errors. Anyone know where to go to fix
this,
or what went wrong in the first place?

Jacob Meadows