We've had these X60 tablets for two years and never experienced this error after imaging. Now when we try to put the image on the X60, it starts to load windows and then blue screens within the first 5 seconds with the following stop message:

"A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:

Disable or uninstall any anti-virus, disk defragmentation or backup utilities. Check your hard drive configuration, and check for any updated drivers. Run CHKDSK /F to check for hard drive corruption, and then restart your computer."

We've rebuilt the master image several times in the last week and get the same error whenever we try to image a machine with one of these recent images.

An image that we built at the end of May works without a problem when we load it instead of one of the newer images.

We also discovered if we take one of the imaged computers that gives the blue screen, boot it up with a windows cd, run chkdsk, fixboot, and fixmbr we can get the image to work. I don't want to do this on the 162 student computers that are coming in next week, however.

We do not use Symantec for our virus protection we use Sophos.

We are using ZenImaging 7.01

Any ideas on what the source of this problem might be?