This is doing my head in...I can't mount a partition that I am sure was mounted in the past and has some VM files on it.

I have a RAID 5 array with two logical disks:
/dev/cciss/c0d0 contains the linux / partitions and swap. No probs there.
/dev/cciss/c0d1 Contains an NSS partition/pool and two linux native partitions, most likely ext3.

The NSS volumes in /dev/cciss/c0d1p1 mount fine and are used in production.

Here some detail of the logical drive...
# fdisk /dev/cciss/c0d1 -l

Disk /dev/cciss/c0d1: 578.9 GB, 578963355648 bytes
255 heads, 32 sectors/track, 138576 cylinders
Units = cylinders of 8160 * 512 = 4177920 bytes

Device Boot Start End Blocks Id System
/dev/cciss/c0d1p1 1 100393 409603424 65 Novell Netware 386
/dev/cciss/c0d1p2 100395 105535 20972857+ 83 Linux
Partition 2 does not end on cylinder boundary.
/dev/cciss/c0d1p3 105535 109392 15735667+ 83 Linux
Partition 3 does not end on cylinder boundary.

# mount /dev/cciss/c0d1p3 /mnt/vm
mount: /dev/cciss/c0d1p3 already mounted or /mnt/vm busy

Is is OK to have NSS and EXT partitions on the same logical drive?
Which tools should I be using to work with non-nss partitions on /dev/cciss/c0d1 - evmsgui, yast or iManager?

If I can't mount partitions p2 and p3 I may have to try to delete them...

Advice much appreciated.

- Paul