Not having done much Satellite work, other than the basic setup, I was
a bit puzzled when I made a new 10.2 satellite.

It will replicate 50 files in each time the content worker thread is
activated (ie. through ZAC CDP).

But I had the content cycle set to 60 minutes, because that worked
well in pre 10.2 systems. Where I would just do a ZAC CDP, and then
the content rolled up. And the satellites would leave the primary
alone for 60 minutes :-)

But has it always been this way in pre 10.2 systems? That it will take
only 50 files in each turn?
I had 750 files, so I set it to back to 5 minutes, and then it
replicated the content in a resonably amount of time.