Hi,

Server and client: 10.2.1.

I have a lot of difficulties in registering devices.

Tested different scenarios:

a)defined a folder /Workstation/TestFolderA
defined a workstation group /Workstation/TestFolderA/WSGroupA
defined a registration rule where "hostname" - "contains" - "install"
=> devices with "install" in the hostname should be registered
in TestFolderA and WSGroupA
=> result: sometimes the registration was ok and sometimes not.
(the manual registration with "zac reg https://..." is ok)

b)defined a folder /Workstation/TestFolderA
defined no workstation group
defined a registration rule where "hostname" - "contains" - "install"
=> devices with "install" in the hostname should be registered
in TestFolderA
=> result: sometimes the registration was ok and sometimes not.
(the manual registration with "zac reg https://..." is ok)

c)defined a dyn workstation group /Workstation/DynTestA
in this group, I added a filter: "hostname" - "contains" - "install"
defined no other registration rule under
"Configuration" - "Registration"
=> devices with "install" in the hostname should be registered
in DynTestA
=> result: the device was created in the Workstation folder but I
had to correct the filter in DynTestA and click on
"Preview Members". In that case, the registration of the device
was ok.
But it was not an automatic run.

In /var/opt/Novell/logs/zenworks/service-messages.log there were no
evident error messages (for me!) concerning registration .

Most curious thing is that once the registration is ok and 15
minutes later it fails - and I made no changes in ZCC (and reimaged
the client to initial state).

Now my please:
If you have no difficulties in registering devices, please can you
tell me, what Folders, Workstations Groups or Dyn. WS Groups you
use and how are defined your registration rules?

Thanks and best regards
Bernhard