This may be a silly question, but I'm not expert in this area. We run
BM3.7
on NW6 and need to set up a single static NAT from one outside address
to
one of our internal machines. We will continue to have dynamic NAT as
well.
I have added a secondary IP address OK (192.168.1.2 mask FF.FF.FF.0)
but
can't get it to bind to the public interface (192.168.1.1). INETCFG
says
"Cannot allow more than one binding for same subnet on same board.".
Can anyone help?
TIA, Bill

This e-mail is strictly confidential and intended solely for the
person or
organisation to whom addressed. If you are not the intended recipient,
you
should not copy it or use it for any purpose, nor disclose its
contents to
any other person. Please notify us immediately by e-mail if you
receive
this communication in error. The views expressed here are the personal

views of the sender and do not necessarily represent those of Thomas Tunnock Ltd.