Hello All,

After fighting this issue all day, I figure I'll throw it out and see if anyone has a hunch for me to follow.

Essentially I've got a ZCM 10.2.1 server in the server farm, and a machine here sitting next to me on another subnet.

Originally I got a "boot filename not received" error, however I found a Novell TID on that which mentioned that after updating to 10.2 the proxydhcp service is set to manually start. After I started it, I got on to the next problem.

The machine is running a Broadcom Netxtreme network card, and I saw a TID earlier about a problem requiring a smaller sized version of nvlnbp.sys with netxtreme cards, however we are running an even newer version of that file than mentioned in that TID.

Basically, what happens is that the Novell Preboot Server is automatically selected properly, and the preboot execution agent loads. Then it begins "Sending queries" to the PXE server IP, and a moment or two after this it gets "PXE-M0F : Exiting Broadcom PXE ROM.

Here's the contents of the screen:
================================================== ===
CLIENT MAC ADDR: 00 19 b9 24 BA 05 GUID: 44454C4C 3200 1054 8034 C6C04F4A4331
CLIENT IP: 149.164.13.3 MASK: 255.255.255.0
DHCP IP: 149.164.187.109 PROXY IP: 149.164.3.210
GATEWAY IP: 149.164.13.254

Auto-select:
Novell Preboot Server -- 149.164.3.210

BOOT SERVER IP: 149.164.3.210

Novell PreBoot Execution (PXE) Agent v10.2.0.0
Copyright Novell, Inc. All Rights Reserved
Sending queries to 149.164.3.210
PXE-M0F: Exiting Broadcom PXE ROM.

Selected boot device not available -
Strike F1 to retry boot, F2 for setup utility
================================================== =====

(Continued in next post due to length)