BM37FP3D on NW6.0SP3.

When I had filter debug enabled and SET TCP DISCARD FILTER
DEBUG=1,
I noticed on my logger screen that the below entries were from the
same Source Address, but the Destination Port Range was being decremented
in each entry.

Does this mean that someone at the Source Address of 212.68.217.249 is
scanning my ports? I was not doing anything (I don't think) on my
server at the time that these messages popped in.

I also noticed the same entries for Source Address 130.57.4.18. This
shows as a Novell IP if I go to HTTP://130.57.4.18.

What do these entries represent and how can I deny any/all inbound
traffic from these IP addresses?

Thanks for the assist.

========[Begin Logger Screen
Snip-It]=============================
Dynamic rule from "Exceptions" list

Protocol Type=(TCP)

Source Interface Type=(Any) Destination Interface
Type=(BOARD_NETWORK)
Source Address=(212.68.217.249) Destination Address=(206.x.x.x)

Source Interface Number=(1) Destination Interface Number=(1)

Source Port Range=(80-80) Destination Port
Range=(4213-4213)
Source TOS=(HTTP) Destination TOS=(Dynamic)

Source Group Name=(None) Destination Group Name=(None)

Source Group ID=(0) Destination Group ID=(0)

Source Remote System ID=(None) Destination Remote System
ID=(None)
Source Circuit=(103) Destination Circuit=(103)

************************************************** *************************
***
Removed1 rule from "Exceptions" list

Protocol Type=(TCP)

Source Interface Type=(Any) Destination Interface
Type=(BOARD_NETWORK)
Source Address=(212.68.217.249) Destination Address=(206.x.x.x)

Source Interface Number=(1) Destination Interface Number=(1)

Source Port Range=(80-80) Destination Port
Range=(4213-4213)
Source TOS=(HTTP) Destination TOS=(Dynamic)

Source Group Name=(None) Destination Group Name=(None)

Source Group ID=(0) Destination Group ID=(0)

Source Remote System ID=(None) Destination Remote System
ID=(None)
Source Circuit=(103) Destination Circuit=(103)

************************************************** *************************
***
Dynamic rule from "Exceptions" list

Protocol Type=(TCP)

Source Interface Type=(Any) Destination Interface
Type=(BOARD_NETWORK)
Source Address=(212.68.217.249) Destination Address=(206.x.x.x)

Source Interface Number=(1) Destination Interface Number=(1)

Source Port Range=(80-80) Destination Port
Range=(4212-4212)
Source TOS=(HTTP) Destination TOS=(Dynamic)

Source Group Name=(None) Destination Group Name=(None)

Source Group ID=(0) Destination Group ID=(0)

Source Remote System ID=(None) Destination Remote System
ID=(None)
Source Circuit=(103) Destination Circuit=(103)

************************************************** *************************
***
Removed1 rule from "Exceptions" list

Protocol Type=(TCP)

Source Interface Type=(Any) Destination Interface
Type=(BOARD_NETWORK)
Source Address=(212.68.217.249) Destination
Address=(207.182.230.139)
Source Interface Number=(1) Destination Interface Number=(1)

Source Port Range=(80-80) Destination Port
Range=(4212-4212)
Source TOS=(HTTP) Destination TOS=(Dynamic)

Source Group Name=(None) Destination Group Name=(None)

Source Group ID=(0) Destination Group ID=(0)

Source Remote System ID=(None) Destination Remote System
ID=(None)
Source Circuit=(103) Destination Circuit=(103)

************************************************** *************************
***

========[End Logger Screen
Snip-It]=============================