I've got an IBM Eserver X360 here where my two secondary hard drives are not seen by Netware.

I'm using the onboard AIC-7892 controller, and all drives are being detected during startup, at ID's 12, 13, 14.

(The SCSI ID's are hard coded on this server based on the slot the drive is inserted in)

However, only the drive at ID12 is being seen by the system. NSSMU only reports one device at C:0000, despite doing a scan.

SCSIHD.CDM is only being loaded once, as is ADPT160M.HAM. I attempted grabbing an older version of this driver to no avail.

The configuration under ScsiSelect for all drives are identical.

Any ideas?