## how do you sysprep

Hi again: With ZDM7, I set up a sequence of vbs scripts (based on some from a cool solution) to aid in post imaging setup. In general, I would run sysprep on the prototype computer prior to imaging. This image would then be used for all my reimaging tasks.

The reimaging sequence was generally:
1. Push down image
2. Let sysprep do its initial work
3. Install Novell client, iprint and zfdagent
4. Let ZISWIN set iimagesafe data
5. Final tasks.

This has worked well for me for many years. However, now that I am moving into zcm territory I need to look at how I will need to image workstations going forward.

How do you handle imaging workstations using sysprep? When is the adaptive agent installed?

Thanks for your time, Chris.