I'm not sure if this should be here or in the Groupwise forum, but I'll
start here. I have a Border 3.8 server that crashed because of a power
surge. Several hardware components were damaged and a new server was
installed in its place. Everything seems to be working at my main
location; however, I have two remote Groupwise post offices that will not
open. If the MTA is reset on the Groupwise server, they both open for a
few seconds and then close again. Nothing has changed on the Groupwise
server, so I feel like the problem is that something was missed on the
Border setup. Are there any special filters that need to be added to
remotely communicate with a post office? Thanks in advance.