Simple question this, I've been running the file copy part (ie step 1) of
the migration wizard for over 2 hours, and it's only just copied one of our
small PO's, about 2 GB in size. GroupWise is tiny files but at this rate,
this whole migration is still going to be running on into next week!

Seriously, is their something I should of done first? Both source and
destination, and workstation are on the same GB switch, and they are both
"clean boots" as per the recommendations.

I'm a bit concerned that this genuinely wont complete - should I abandon and
consider a tape restore of the GroupWise data once the migration is done?