GW8hp1 running on oes2sp2,
The following is the input and the output when I attempt to start GWIA

SVUSD1:/opt/novell/groupwise/agents/bin # ./gwia --show @gwia.cfg &
[1] 2300
Warning: Running as root

SVUSD1:/opt/novell/groupwise/agents/bin # Unable to process startup file 'gwia.cfg'.

[1]+ Segmentation fault ./gwia --show @gwia.cfg
SVUSD1:/opt/novell/groupwise/agents/bin #

I searched for a gwia.cfg file and can't find one. This is probably related to the earlier posted where the gui that is used to config gwia after install, never finished the config. I had a spinning wheel of death, there was no finish to the config, so I am assuming that the config file never was written. I tried running the config twice with the same results...