Hi all.

Think i might out found a tiny bug in ZCM 10.3a, but i need someone to test and clarify for me if possible.

Create a new bundle, and give it a Install or Launch action of "Launch a Windows Executable".
Open the Launch Executable action.
Select the Advanced tab.
Set "Wait before proceeding to next action" to either "When action is complete" or "Wait for X seconds".
Press OK.
Press Apply to save changes.

Now, using IE7 (IE8 and Firefox seem fine)
Go back into the Launch Executable action.
Select the Advanced tab.
The "Wait before proceeding to next action" option is now set to "No wait" and whatever else you previously set, so both radio buttons are selected.
Press OK.
Press Apply to save changes.
The option will have now re-saved as "No wait".


So basically, if you open up the launch executable action, and select the Advanced options using IE7 (maybe IE6 too???) it will reset the "Wait before proceeding to next action" option back to "No Wait". But only sticks if you apply the bundle changes.


Hope that makes sense. Could someone with a ZCM 10.3a system, and IE7 test and confirm this for me please?

Thanks