Hello,

I set up a Bordermanager 3.6 VPN. If I dial into an ISP I can connect
and
ping hosts on the private network. However, I am trying to setup a
client
at another location that has a ADSL modem and a router. The router is
a
Cisco PIX 501. I have read on Craig Johnson's site a list of routers
that
will and will not work on the client side. (I think this is in
regards to
the client side). I am going to buy one of the routers on the list
and
try it instead of the Cisco Pix but I am worried something else might
me
wrong. The private IP address pool on the client side is a different

network than the private ip's on the VPN network and different from
the
VPN tunnel. Should this work? The Master VPN server is running nat
and
is connected to a cable modem. The ADSL router at the client site
uses
PPPoe. Is this OK? Thanks for any help.
Bonnie