Hello,

could anyone give me a hint, how to tell my netware DHCP to use a Windows Server 2008 R2 running Acronis with PXE Server?

Actual Situation:
Netware 6.5 Sp8 Server with ZENWORKS in Cluster mode
Netware DHCP Server
ZEN7 SP1 Imaging
--> works fine so far, and no problem in other subnets, IP-helper are configured in the switches
New Situation:
Netware 6.5 Sp8 Server with ZENWORKS in Cluster mode
Netware DHCP Server
Windows Server 2008 R2 running Acronis Snap Deploy with PXE-Server - in future may be a clean Windows Deployment service without Acronis
--> that would be nice :)

I found serveral ini-files (dts.ini, pdhcp.ini, tftp.ini) where I configured the new IP-Address of the W2k8 PXE Server.
Now:
The Client gets its correct IP-Address from Netware DHCP

but after that the following messages:

Auto-select:
ZENworks Boot
Boot Server IP: --.--.--.-- (the correct one configured in the ini-files!)
TFTP.
PXE-T02:
PXE-E3C: TFTP Error - Access Violation
PXE-M0F: Exiting Intel Boot Agent

Any ideas?

Thanks a lot.