Home

Results 1 to 3 of 3

Thread: ZENworks 11.4.2 logging

  1. #1
    Join Date
    Jun 2016
    Posts
    60

    ZENworks 11.4.2 logging

    Not sure if this is the right place for this question, but here it goes. I am seeing a lot of generic errors within the ZENworks Control Center for different bundles, but they don't have much information on them. I know there is a lot more information within the local logs that I cannot access, due to user is busy or access restrictions. Is there a way to have the ZENworks Agent write the logs to a different location rather than locally? Perhaps to a shared folder on a network drive? I'm not sure if there is a config file that tells it where to write the logs to but it would be very helpful if all the device logs were in a centralized location rather than only saved on the workstation.

  2. #2
    Join Date
    May 2016
    Posts
    1,719

    Re: ZENworks 11.4.2 logging

    schiess,

    It appears that in the past few days you have not received a response to your
    posting. That concerns us, and has triggered this automated reply.

    These forums are peer-to-peer, best effort, volunteer run and that if your issue
    is urgent or not getting a response, you might try one of the following options:

    - Visit https://www.microfocus.com/support-and-services and search the knowledgebase and/or check
    all the other self support options and support programs available.
    - Open a service request: https://www.microfocus.com/support
    - You could also try posting your message again. Make sure it is posted in the
    correct newsgroup. (http://forums.microfocus.com)
    - You might consider hiring a local partner to assist you.
    https://www.partnernetprogram.com/pa...nder/find.html

    Be sure to read the forum FAQ about what to expect in the way of responses:
    http://forums.microfocus.com/faq.php

    Sometimes this automatic posting will alert someone that can respond.

    If this is a reply to a duplicate posting or otherwise posted in error, please
    ignore and accept our apologies and rest assured we will issue a stern reprimand
    to our posting bot.

    Good luck!

    Your Micro Focus Forums Team
    http://forums.microfocus.com



  3. #3
    strj500 is offline Micro Focus Employee - Ultra Contributor
    Join Date
    Feb 2015
    Posts
    133

    Re: ZENworks 11.4.2 logging

    I don't there's a file to automatically configure (welcome corrections if I'm wrong). You can specify the location by zac zeninfo <new_location>, for example zac zeninfo -C:\, you could likely make a bat file do that for you.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •